Piezometers


Casagrande Standpipe Piezometer

Casagrande Standpipe Piezometer EPB0009J

The Casagrande Standpipe Piezometer measures pore water pressures and water levels in a simple and cost effective manner.


M-206 piezometer

M-206 Piezometer

The piezometer can be pressed down without pre-drilling, normally until approximately 30 m depth. Intended for Ø32 mm extension tube. Adapters to 1" water pipe can be delivered.

Easy to install
Simple and robust design
For measurement of groundwater level and pore pressure
Push-inn penetration without pre-drilling
Supplied with bronze filter
Read by using a specially designed water-level gauge

M-600

M-600 Piezometer

• For direct push-in penetration use without pre-drilling
• Quick installation in soft and loose soils
• Short response time
• Accuracy better than ± 0.5% FS
• Pressure range 2 to 30 bar


M-610

M-610 Piezometer

• Designed for direct mounting
• Suitable for use in dams, landfills, environmental wells or similar
• Housing of stainless steel, other materials such as titanium are available on request
• Measuring range 2 to 30 bar.

Multi-Point Piezometer String



Multi-Point Piezometer String MiB0051C

Multi-point Piezometer Strings allow for multiple Vibrating Wire Piezometers to be connected on a single cable. This facilitates the installation of fully grouted multiple piezometers. The single cable prevents vertical void channels.

Pneumatic Piezometer


Pneumatic Piezometers PPB0001E

Pneumatic Piezometers utilize water and gas pressures to measure pore-water pressure.


Push In Standpipe Piezometer

Push-in Standpipe Piezometer WLB0007C

RST’s Push-in Standpipe Piezometer is used in soft clays, organic and fine grained cohesionless soils. It is also ideal for slope stability investigation and leachate extraction. The piezometer unit is designed for extremely quick and easy field assembly.

Strain Gauge and Vibrating Wire Pressure Transducer

Strain Gauge and Vibrating Wire Pressure Transducers ELB0032C

Vibrating Wire Piezometer

Strain Gauge and Vibrating Wire Pressure Transducers are used for uplift measurement in the foundation of concrete dams, overflow settlement measurement in earthfill and rockfill dams, and all other applications where a rugged and reliable pressure
transducer is required for measuring fluid pressure in closed circuits.

Vibrating Wire Piezometers ELB0003U

Vibrating Wire Piezometers allow for measurements of pore water pressure under the most adverse conditions.

Water Level Meter

Water Level Meter WLB0002E

RST Water Level Meters are designed to measure the elevation of groundwater in boreholes, standpipes and wells.



© Geonor, Inc. 2013 - 2014